Timing LED digital tube circuit board can control motor with manual switch or transmitter and it also can make motor rotate automatically if you preset time for rotation or stop. LED digital tube displays motor working time and motor working status. You can read all data from digital tube easily.
From right to left, there are four buttons on the circuit board. S1 is setting button (SET), S2(+)and S3(-) is adjustable button, S4 is learning button.
In order to make motor work automatically, we should set inner clock of this remote controller firstly. Suppose that the real time of setting is 14:56, February, 19th 2014, Wednesday.
Press S1, controller enters into the status of “date and time setting”.
Press S1 again to set “Year” to “2014”.
Press S1 again to set “Month” to “02”.
Press S1 again to set “Date” to ”19”.
Press S1 again to set “Hour” to “14”.
Press S1 again to set “Minute” to ”56”.
Press S1 again to set “Week” to” 3”.
The correspondent data will flash when we are setting. Then, press S2(+) or S3(-) to adjust according to your need. Press S1 again to save data and log out automatically when week setting is finished. After setting, we can see the following picture. The LED digital tube will read those data.